Industrial curing systems,
built to spec.
UV curing, tunnel ovens, industrial ovens, dispensing, coating, welding and cleaning equipment — configured per process segment, delivered as single machines or full lines.
Representative machines
One proven configuration from each of our main lines — every unit is sized to the workpiece and the line rate.
01
UV LED curing machine DH-UV600
600 mm effective width dual-lamp UV LED curing machine, two-stage independen…
02
Hot air circulation tunnel oven DH-TO450
Four-zone hot air circulation tunnel oven, maximum 450 ℃, independent PID te…
Configured around your process
We start from the workpiece and the takt time, not from a catalogue. Every unit is sized, simulated and validated before shipment.
Process-first sizing
Machine width, lamp power and conveyor speed are derived from part geometry and required line rate.
Thermal simulation
Airflow and temperature fields are modelled before fabrication to avoid hot spots and uneven cure.
Line integration
Mechanical, electrical and signal interfaces are matched to your existing conveyor or robot cell.
Validation & handover
Factory acceptance runs with your samples, documented parameters and on-site commissioning.
Consumables & spares
Lamps, nozzles, belts and filters are kept in stock for the lifetime of the machine.
Documentation
Electrical drawings, spare-part lists and maintenance schedules delivered in your language.
Where our equipment runs
Production floors in electronics, automotive, medical, packaging and metal finishing.
From specification to commissioning
A typical line ships in 25–45 working days after drawing approval, depending on chamber size and control scope.
Start a projectRequirement review
Samples, drawings and takt time reviewed by an application engineer.
Proposal & drawing
Layout, utility requirements and a fixed quotation within five working days.
Build & FAT
Fabrication, assembly and a factory acceptance run with your parts.
Install & train
On-site commissioning, operator training and handover documents.
Technical notes
Technical guide
UV Curing Energy Calculation: Conversion between mJ/cm² and mW/cm² and Production Line Matching
UV curing failure is usually not due to insufficient lamp brightness, but incorrect energy d…
Read the note
Tell us your process.
Share workpiece material, size, throughput and current line setup. Our engineers reply with a configuration and a realistic lead time.